So my question is, should i dissasamble the card and look for some damage and post the pictures here or could this be still a psu problem ?Blinking Green Power or System Light-Emitting Diode (LED) for Intel® Server Boards and Intel® Server Systems The card was working on the 1000w dark power pro before so the abnormal power supply problem is out of question. When I go to power it on I see the internal fans/lights turn on however my video card and motherboard CPU LED blink red every 5 seconds.White leds blinking over the power connector and no fans spinning. Motherboard: Gigabyte Z590 Vision D ATX LGA1200 The error code LED on the motherboard does not light up. Check EZ Debug LED indicator EZ Debug LED is located on the side of 24pin ATX power connector. Clear the BIOS data by moving JBAT1 from its original 1-2 position to 2-3 position after discharge the computer You can also remove the CMOS battery for about five minutes from your motherboard.Here are things I've tried: Pulling the mobo battery and waiting a minute As soon as I plug it in and power it on, the motherboard light comes on solid for a second and then starts rapidly blinking. Rule 2// The screw holes between the two fans must be 15mm width on the radiator for either 120mm or 140mm UNI FAN.Orange blinking light on motherboard (B450M DS3H gigabyte) I have a used Gigabyte B450M motherboard. Rule 1// The tubes of the radiator must avoid the tenon of the UNI FAN and be at the safe area, which is in grey in the image. Radiators that doesn’t follow bellow rule:.CORSAIR Hydro Series™ H110i GT 280mm Extreme Performance Liquid CPU Cooler.CORSAIR iCUE H115i RGB PRO XT Liquid CPU Cooler.Listed radiators are known not compatible with UNI FAN.To connect more devices, please update to L-Connect 2 (reference to update guide) and use 2 or more controllers. Do not connect more than 10 UNI FANs (device up to 21W) to the controller (UNI HUB) when performing white static color.(Update your motherboard BIOS if necessary) Please enter your motherboard BIOS and set the correspondent fan header at PWM mode.Please note that the single-pack version does not contain this controller. To control all 16 UNI FANs (4 fans each cluster) in one go, a controller is needed, no matter control with L-Connect software or sync to the motherboard. Purchase a three-pack SL120 or a two-pack SL140(including a controller) as the starter kit for fully experienced UNI FANs with L-Connect.

Rgb fans that work with rgb fusion